BodyCraft BCG 446 User Manual download pdf (Page 12)

(45a)

T2,T4

T9,T10

STEP 1

Figure 1

T10

T11

Figure 1

45a

T3, T5

STEP 6 INSTALL TOP CABLE

T11

Insert the threaded end of the TOP CABLE(45a) into the pulley slot in the front of the TOP

FRAME(10) over pulley T1 and back to pulley T2 on the PRESS UPRIGHT(3). Route cable

over and around Pulley T2, exiting from bottom. Then route cable over top of Pulley T3 [you

will mount two pulleys side-by-side here. T3 is the right side (as if sitting on seat) pulley],

around to bottom of pulley T4. Route cable from bottom of T4, exiting on top, to top of

Pulley T5. Exit from bottom of T5 and route to bottom of pulley T6 mounted in the PRESS

UPRIGHT(3). Run cable along the bottom of T6, and the up and over pulley T7 mounted in

TOP FRAME(10). Attach a pulley in the top hole (closed end) of a FLOATING PULLEY

BLOCK(29). This will be pulley T8 and will dangle from the TOP CABLE(45a) as shown in

Figure 1. Route cable under pulley T8, and over top of Pulleys T9 and T10. The screw end

of cable into the Top Plate about 1/2 way. The cable must always be screwed into the TOP

PLATE(8) at least 1/3 of the way, and locked into place with the locking nut.

Attach Pulley T6 to the PRESS UPRIGHT(3) using one 3/8" x 2-3/4" HEX BOLT(79), two 3/8"

WASHERS(90), two 3/8" ID x 10mm PLASTIC BUSHINGS(68), and one 3/8" NYLON NUT(87).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

No comments

BodyCraft BCG 446 User Manual Page 12