BodyCraft X Press User Manual download pdf (Page 6)

106

100

101

106

101

107

106

107

101

109

101

106

STEP 1 ASSEMBLE MAIN FRAME

To ease the assembly process, do not tighten bolts until instructed.

1. Attach Rear Stabilizer(2) to Base Frame(1) using two 3/8"X3" Bolts(88), four 3/8" Washers(101) and two

Nuts(107). Attach Front Stabilizer(10) and Low Row Connector(13) to Base Frame(1) using two 1/2"X3"

Bolts(85), and two Nuts(106). Cap Rear Stabilizer and Front Stabilizer with four 50mm SQ. Cap(40).

2. Attach two Foot Plate Stoppers(65) onto Low Row Connector(13). Attach the Foot Plate(14) to Low

Row Connector(13) by aligning the holes and inserting Foot Plate Roller(15).Insert two 1" Round Plug

(46) into the Foot Plate Roller(15).

3. Attach Rear Upright(3) to Rear Stabilizer(2) using two 1/2" Washer(100) and Nuts(106).

4. Attach Front Upright(4) to Base Frame(2) using two 3/8"X3" Bolts(88), four Washers(101) and two Nuts

(107).

5. Attach Top Frame(5) to Front Upright(4) using two 1/2"X4" Bolts(84) and two Nuts(106). Attach Top

Frame(5) to Rear Upright(3) using two 1/2"X3" Bolts(85) and two Nuts(106).

6. Insert four Plastic Guide Rod Holders(47) into Base Frame and Top Guide Rod Retainer(7) as shown.

Slide a Rubber Donut(63) onto one end of each Guide Rod(6) and then insert the Guide Rods into

the Plastic Guide Rod Holders in Base Frame as shown.

7. Slide each 10 Lb. Plate(68) over guide rods. Make certain that each plate is oriented with selector

hole on bottom and facing forward. Attach Top Plate(67) to Selector Rod(69) using Top Plate Bolt(109).

Slide Top Plate and Selector Rod(69) onto Guide Rods(6).

8. Slide Top Guide Rod Retainer(7) over top of Guide Rods(6) and attach Top Guide Rod Retainer(7) to

Top Frame(5), using two 3/8"X2-3/4" Bolts, four 3/8" Washers and two Nuts(107). Attach 50mm Plug

onto Rear Upright(3) and 30mmX60mm Plug onto rear of Top Frame

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

BodyCraft X Press User Manual Page 6