BodyCraft BCG-GX User Manual

GX STRENGTH TRAINING SYSTEMINSTRUCTION MANUALMODEL BCG-GXMZ6881CBodycraft is a division of Recreation Supply Inc.P.O. BOX 181Sunbury,

9STEP 4 ASSEMBLE PRESS STATION9511511512311228769691128513268681. Attach Press Arm Support (13) to the Top Frame (2) by aligning the holes and inse

STEP 5 ASSEMBLE SEAT FRAME AND SEAT & BACK PAD1. Attach Seat Frame (9) to Front Upright (3), using three 3/8" X 3" Hex Bolts (99) six 3

11STEP 6 INSTALL TOP CABLEPulleys T3 and T5 are mounted to either side of the steel tab. Do not mount both pulleys to one side. Assemble cables a

12STEP 6 INSTALL TOP CABLE

13STEP 7 INSTALL AB CABLE1. Run the steel ball end of the Ab Cable (88) through the slot in the Front Upright (3) and attach two pulleys in the slo

14STEP 8 INSTALL LOWER CABLE1. Route the steel ball end of the Lower cable (89) under Pulley L1 mounted at the front of the Low Pull Station using

15STEP 9 INSTALL CONNECT CABLE1. Hook the steel ball end of the Connect Cable (90) to the receptor C1 welded to the Base Frame (1). Route the cabl

16STEP 10 INSTALL CABLE ARM CABLE1. The Cable Arm Cable (91) is already run through the Cable Arms (14). Mount Pulleys P3 and P7, along with thei

17STEP 11 INSTALL WEIGHT STACK SHROUDSASSEMBLY IS COMPLETE! Tighten all bolts, starting with main frame bolts on the base, and work way to top.1.

18STEP 12 INSTALL ACCESSORIES434546464646432924246301. Attach Lat Bar (29), Curl Bar (30), Single Handle (43), to the GX Strength Training System.

BEFORE YOU BEGINCongratulations and thank you for selecting the BODYCRAFT GX strength training system. The BODYCRAFT GX offers an impress

a. The Cables should be tightened to the point just before the Top Plate lifts off the stack. In other words, if the Top Plate is not resting on the

Assembly is complete! Please take the following steps before using the gym:1.2.3.4.5.6.7.Make certain all bolts are tightened securely.Make c

123456789101112131415161718192020A21222323A24252626A272829303132333435363738394040ABASE FRAMETOP FRAMEFRONT UPRIGHTREAR UPRIGHTGUIDE RODLEG EXTE

414243444546474849505152535455565758596061626364656667686970717273747576777879808182838485868788899091929394243L NONSLIP AB CRUNCH STRAPSINGLE HAN

95 96 97 98 98A 9910010110210310410510610710810911011111211311411511611711811912012112212312412512612712812911222131232481104482172225010422821

6STEP 1 ASSEMBLE BASE FRAME 2. Attach Rear Upright (4) to Base Frame (1), using three 3/8" X 3/4" Hex Screws (109) and three 3/8" W

7STEP 2 ASSEMBLE TOP FRAME1. Insert Guide Rod Mount (129) onto the Guide Rods (5), then attach to Top Frame (2) using two 5/16" X 5/8" Bo

8STEP 3 ASSEMBLE CABLE ARM ASSEMBLYRemember to keep all BOLTS loose to ensure the holes will align easily.1. Attach Cable Arm Assembly (11) to Cab